Purdy AND262HBB - Manual

Purdy Electronics Corporation • 720 Palomar Avenue • Sunnyvale, CA 94086
Tel: 408.523.8200 • Fax: 408.733.1287 • [email protected] • www.purdyelectronics.com 6-1-99
AND262HBB
Ultra Bright LED Lamps: Type 3
Weight: 0.14g Unit: mm
AND262HBB
InGaN High Brightness Blue Light Emission
• 3 mm (T-1) Package
• Peak wavelength (
λ p = 470nm) high bright emission
• All plastic mold type, clear colorless lens
• Low drive current: 1 to 20 mA DC
• Excellent On-Off contrast ratio
• Fast response time, capable of pulse operation
• High power intensity
• High reliability
• RoHS compliant
Maximum Ratings (T
a
= 25°C)
Characteristics Symbol Rating Unit
Forward Current I
F
30 mA
Reverse Voltage V
R 5 V
Power Dissipation P
D 100 mW
Operating Temperature Range T
Opr
-40 to 85 C
Storage Temperature Range T
Sig
-40 to 100 C
Precaution
Please be careful of the following:
1. Soldering temperature: 260 C max.
Soldering time: 5 sec. max.
Soldering portion of lead: up to 1.6 mm from the body of the device
2. The lead can be formed up to 5 mm from the body of the device without forming stress.
Soldering should be performed after the lead forming.
3. Absolute secure counter measures against static electricity and surge should be taken when handling these
products. It is recommended to use wrist band or antistatic gloves when handling these LEDs
Electro-Optical Characteristics (T
a
= 25°C)
Characteristics Symbol Test Condition Minimum Typical Maximum Unit
Forward Voltage V
F
I
F
= 20 mA – 3.5 4.0 V
Reverse Current I
R
V
R
= 5V – – 10 µA
Luminous Intensity I
V
I
F
= 20 mA 150 300 – mcd
Peak Emission Wavelength λ
P
I
F
= 20 mA – 470 – nm
Spectral Line Half Width ∆ λ I
F
= 20 mA – 40 – nm
Dominant Wavelength λ d I
F
= 20 mA 465 – 475 nm
Full Viewing Angle θ I
V
= 1/2 Peak – 45 – degree