Purdy AND410HB - Manual

Purdy Electronics Corporation • 720 Palomar Avenue • Sunnyvale, CA 94085
Tel: 408.523.8200 • Fax: 408.733.1287 • [email protected] • www.purdyelectronics.com 7/18/07
AND410HB
Ultra Bright LED Lamps: Type 3
Weight: 0.31g Unit: mm
1.0 MIN.
1.0
± 0.2
1.5 MAX.
8.6
±
0.3
5.9
±
0.3
5.0 ±0.2
25.4 MIN.
0.5
2.54
0.65 MAX.
AND410HB
GaN High Intensity Blue Light Emission
• 5 mm (T1-3/4) Package
• Available on tape and reel
• Peak wavelength (lp = 430nm) high bright emission
• All plastic mold type, clear colorless lens
• Low drive current: 1 to 20 mA DC
• Excellent On-Off contrast ratio
• Fast response time, capable of pulse operation
• High power intensity – suitable for indoor/outdoor applications
• High reliability
• RoHS Compliant
Maximum Ratings (T
a
= 25°C)
Characteristics Symbol Rating Unit
Forward Current I
F
30 mA
Reverse Voltage V
R
5 V
Power Dissipation P
D
140 mW
Operating Temperature Range T
Opr
-40 to 85 C
Storage Temperature Range T
Sig
-40 to 100 C
Precaution
Please be careful of the following:
1. Soldering temperature: 260 C max.
Soldering time: 5 sec. max.
Soldering portion of lead: up to 1.6 mm from the body of the device
2. The lead can be formed up to 5 mm from the body of the device without forming stress.
Soldering should be performed after the lead forming.
3. Absolute secure counter measures against static electricity and surge should be taken when handling these products. It is
recommended to use wrist band or antistatic gloves when handling these LEDs.
Electro-Optical Characteristics (T
a
= 25°C)
Characteristics Symbol Test Condition Minimum Typical Maximum Unit
Forward Voltage V
F
I
F
= 20 mA – 3.8 4.5 V
Reverse Current I
R
V
R
= 5V – – 10 µA
Luminous Intensity I
V
I
F
= 20 mA 250.0 400.0 – mcd
Peak Emission Wavelength l
P
I
F
= 20 mA – 430 – nm
Spectral Line Half Width ∆l I
F
= 20 mA – 65 – nm
Dominant Wavelength ld I
F
= 20 mA 464 – 468 nm
Full Viewing Angle 2 q 1/2 I
V
= 1/2 Peak – 10 – degree
Product specifications contained herein may be changed without prior notice.
It is therefore advisable to contact Purdy Electronics before proceeding with the design of equipment incorporating this product.