Purdy AND190HRP - Manual

Purdy Electronics Corporation • 720 Palomar Avenue • Sunnyvale, CA 94085
Tel: 408.523.8200 • Fax: 408.733.1287 • [email protected] • www.purdyelectronics.com 6/12/07
AND190HRP
Ultra Bright LED Lamps: Type 3
Weight: 1.0g Unit: mm
2.0
±
0.2
13.5
±
0.3
11.0
±
0.3
10.0 ±0.2
25.4 MIN.
1.0 MIN.
1. Anode
2. Cathode
1 2
Cathode Index
0.5
2.54
0.5
AND190HRP
InGaAlP High Brightness Red Light Emission
T-3 Package (10 mm)
Features
• New emission material (InGaAlP) red LED
• Peak wavelength (lp = 644 nm) high bright emission
• All plastic mold type, clear colorless lens
• Low drive current, (forward current = 1 to 20 mA)
• Excellent On-Off contrast ratio
• Fast response time, capable of pulse operation
• High power luminous intensity
• Suitable for Outdoor Message Signboards
Maximum Ratings (T
a
= 25°C)
Characteristics Symbol Rating Unit
Forward Current I
F 50 mA
Reverse Voltage V
R
5 V
Power Dissipation P
D
125 mW
Operating Temperature Range T
Opr
-40 to 85 °C
Storage Temperature Range T
Stg
-40 to 120 °C
Precaution
Please be careful of the following:
1. Soldering temperature: 260°C max
Soldering time: 5 sec. max
Soldering portion of lead: up to 1.6 mm from the body of the device
2. The lead can be formed up to 5 mm from the body of the device without forming stress.
Soldering should be performed after the lead forming.
Electro-Optical Characteristics (T
a
= 25°C)
Characteristics Symbol Test Condition Minimum Typical Maximum Unit
Forward Voltage V
F
I
F
= 20 mA – 1.9 2.4 V
Reverse Current I
R
V
R
= 4 V – – 10 µA
Luminous Intensity I
V
I
F
= 20 mA 5,600 10,000 – mcd
Peak Emission Wavelength l
P
I
F
= 20 mA – 644 – nm
Spectral Line Half Width ∆l I
F
= 20 mA – 20 – nm
Dominant Wavelength ld I
F
= 20 mA – 631 – nm
Full Viewing Angle q I
V
= 1/2 Peak – 8 – degree
Product specifications contained herein may be changed without prior notice.
It is therefore advisable to contact Purdy Electronics before proceeding with the design of equipment incorporating this product.
• RoHS Compliant