Purdy AND157HSP - Manual

Purdy Electronics Corporation • 720 Palomar Avenue • Sunnyvale, CA 94085
Tel: 408.523.8200 • Fax: 408.733.1287 • [email protected] • www.purdyelectronics.com 1/30/07
AND157HSP
Ultra Bright LED Lamps
Weight: 0.31 g Unit: mm
1.0 MIN.
1.0
± 0.2
5.0 ±0.2
8.6
±
0.3
6.0
±
0.2
0.5
24.0 MIN.
2.54
1 2
0.5
1. Anode
2. Cathode
Cathode Index
AND157HSP
InGaAlP High Brightness Soft Red Light
Emission
5mm (T1-3/4) Package
Features
• Peak wavelength (λ p=632 nm) high bright emission
• All plastic mold type, clear colorless lens
• Low drive current: 1 ~ 20 mA DC
• Excellent On-Off contrast ratio
• Fast response time, capable of pulse operation
• High power intensity – suitable for outdoor usage
• High reliability, storage temp. –40 ~ 85°C
Maximum Ratings (T
a
= 25°C)
Characteristics Symbol Rating Unit
Forward Current I
F
50 mA
Reverse Voltage V
R 5 V
Power Dissipation P
D 125 mW
Operating Temperature Range T
Opr
-40 to 85 °C
Storage Temperature Range T
Stg
-40 to 100 °C
Peak Forward Current Duty 1/
10, Pulse Width 10 ms
IFP 160 mA
Precaution
Please be careful of the following:
1. Soldering temperature: 260 C max., Soldering time: 5 sec. max.
Soldering portion of lead: up to 1.6 mm from the body of the device
2. Reflow solder: recommended condition is as follows:
Electro-Optical Characteristics (T
a
= 25°C)
Characteristics Symbol Test Condition Minimum Typical Maximum Unit
Forward Voltage V
F
I
F
= 20 mA – 2.0 2.6 V
Reverse Current I
R
V
R
= 5 V – – 50 µA
Luminous Intensity I
V
I
F
= 20 mA 4,500 5,650 – mcd
Peak Emission Wavelength l
P
I
F
= 20 mA – 632 – nm
Spectral Line Half Width λ ∆ I
F
= 20 mA – 20 – nm
Dominant Wavelength λ d I
F
= 20 mA – 615 – nm
Full Viewing Angle 2 θ 1/2 I
V
= 1/2 Peak – 30 – degree
P roduct specifications contained herein may be changed without prior notice.
It is therefore advisable to contact Purdy Electronics before proceeding with the design of equipment incorporating this product.