Purdy AND5GA - Manual

Purdy Electronics Corporation • 720 Palomar Avenue • Sunnyvale, CA 94085
Tel: 408.523.8200 • Fax: 408.733.1287 • [email protected] • www.purdyelectronics.com 7/18/07
AND5GA
Ultra Bright LED Lamps: Type 2
Precaution
Please be careful of the following:
1. Manual soldering: maximum temperature of iron tip: 260°C max.
Soldering time: within 5 sec. per solder-land
Soldering portion of lead: up to 1.6 mm from the body of the device
2. Reflow solder: recommended condition is as follows:
Electro-Optical Characteristics (T
a
= 25°C)
Characteristics Symbol Test Condition Minimum Typical Maximum Unit
Forward Voltage V
F
I
F
= 20 mA – 2.1 2.4 V
Reverse Current I
R
V
R
= 5 V – – 10 µA
Luminous Intensity I
V
I
F
= 20 mA 75 125 – mcd
Peak Emission Wavelength l
P
I
F
= 20 mA – 570 – nm
Spectral Line Half Width ∆ λ I
F
= 20 mA – 30 – nm
Dominant Wavelength λ d I
F
= 20 mA – 571 – nm
Full Viewing Angle θ I
V
= 1/2 Peak – 30 – degree
more than 2 min.
230 °C max.
140 - 160 °C
Temperature
10 sec. max.
Time
4 °C/sec.
max.
2.5 2.0 2.5
2.5
Reflow
The following soldering patterns are
recommended for reflow soldering
Weight: 2.0 Unit: mm
Cathode Index
ø1.8±0.1
2.0
2.4±0.1
0.5±0.1
2.5±0.2
2.2±0.1 3.2±0.2
Polarity
0.5±0.1
R0.9±0.1
AND5GA
GaP Ultra Bright Green Light Emission
Surface Mount Package
Features
• Small package size with dome lens
• 3.2 (l) x 2.4 (w) x 2.6 (h) size
• Suitable for REFLOW soldering
• Recommended Forward Current: 10 mA
Maximum Ratings (T
a
= 25°C)
Characteristics Symbol Rating Unit
Forward Current I
F
25 mA
Reverse Voltage V
R
5 V
Power Dissipation P
D 60 mW
Operating Temperature Range T
Opr -40 to 85 °C
Storage Temperature Range T
Stg
-40to 90 °C
Product specifications contained herein may be changed without prior
notice. It is therefore advisable to contact Purdy Electronics before
proceeding with the design of equipment incorporating this product.
• RoHS Compliant