Purdy AND4GRA User Manual
And4gra, Features
Purdy Electronics Corporation • 720 Palomar Avenue • Sunnyvale, CA 94085
Tel: 408.523.8200 • Fax: 408.733.1287 •
7/18/07
www.purdyelectronics.com
AND4GRA
Ultra Bright LED Lamps: Type 2
Weight: 2.0 mg
Unit: mm
AND4GRA
InGaN Ultra Bright Green Light
Emission
Surface Mount Package
Features
• Small package size
• 2.0 (l) x 1.25 (w) x 1.1 (h) size
• Suitable for DIP and REFLOW soldering
• Recommended Forward Current: 10 mA
Maximum Ratings (T
a
= 25°C)
Characteristics
Symbol
Rating
Unit
Forward Current
I
F
30
mA
Reverse Voltage
V
R
5
V
Power Dissipation
P
D
120
mW
Operating Temp. Range
T
Opr
-30 to 80
°C
Storage Temp. Range
T
Stg
-40to 100
°C
Precaution
Please be careful of the following:
1. Manual soldering: maximum temperature of iron tip: 260°C max.
Soldering time: within 5 sec. per solder-land
Soldering portion of lead: up to 1.6 mm from the body of the device
2. Reflow solder: recommended condition is as follows:
Electro-Optical Characteristics (T
a
= 25°C)
Characteristics
Symbol
Test Condition
Minimum
Typical
Maximum
Unit
Forward Voltage
V
F
I
F
= 20 mA
3.1
3.5
3.8
V
Reverse Current
I
R
V
R
= 5 V
–
–
100
µA
Luminous Intensity
I
V
I
F
= 20 mA
84
140
–
mcd
Peak Emission Wavelength
l
P
I
F
= 20 mA
–
540
–
nm
Spectral Line Half Width
∆l
I
F
= 20 mA
–
45
–
nm
Dominant Wavelength
ld
I
F
= 20 mA
–
530
–
nm
Full Viewing Angle
2 q 1/2
I
F
= 20 mA
–
120
–
degree
more than 2 min.
230
°C max.
140 - 160
°C
Temperature
10 sec. max.
Time
4
°C/sec.
max.
The following soldering patterns are
recommended for reflow soldering:
3. Absolute secure counter measures against
static electricity and surge should be taken
when handling these products. It is
recommended to use wrist band or antistatic
gloves when handling these LEDs.
Product specifications contained herein may be changed without prior
notice. It is therefore advisable to contact Purdy Electronics before
proceeding with the design of equipment incorporating this product.
• RoHS Compliant