TA Triumph-Adler P-C3065 MFP - Manual (Page 38)

3-7
Sending Faxes > Basic transmission procedure
3 Select [Line Off].
When communication is disconnected, transmission stops.
To cancel direct transmission, refer to the following:
To cancel a delayed transmission or send a fax by immediate transmission, refer to the following:
To cancel polling transmission, refer to the following:
Using redial
Redial is a function allowing you to dial the last entered number once again.
Use this when the receiving system does not respond when you have tried to send a fax. When you want to send the fax
to the same receiving system, select [Address Recall/Pause], and you can call the receiving system you dialed on the
destination list.
1
[FAX] key > [Address Recall/Pause] key
The previously dialed destination is called.
2
Press the [Start] key.
The transmission will start.
NOTE
To cancel direct transmission, delayed transmission, or polling transmission, refer to the
section for that function.
Cancelling Direct Transmission (page 3-19)
Cancelling and Sending Delayed Transmissions (Queued) (page 3-22)
Polling Communication (page 5-15)
NOTE
Recall information is canceled in the following conditions.
• When you turn the power off
• When you send a next fax (new recall information is registered)
• When you log out