TA Triumph-Adler DC 2015 - Manual (Page 37)

CHAPTER 6 COPIER MANAGEMENT
6-6
Default code Setting item Setting contents Setting code
F13 Non-standard size paper width
setting for multi-bypass Sets the paper width for the multi-bypass to use non
standard size paper such as A4 paper.
F14 Output mode Select "Sort ON" to have sorting performed automatically
when the ADF is used. If "Sort OFF" is selected, sorting will
not be performed. To use the sort mode when "Sort OFF" is
selected or when placing originals on the platen, press the
Sort key to light the Sort indicator.
* This setting item will not be displayed if the optional
memory board and ADF are not installed.
1: Sort ON *
2: Sort OFF
F15 Rotate sort Sets whether the normal sort copy (see page 5-6) or rotate
sort copy (see page 5-6) is used when the sort mode is
selected.
* This setting item will not be displayed if the optional
memory board is not installed.
1: ON *
2: OFF
F16 Copy limit Limits the number of copies that can be made at a time. 1 to 250 copies (250
copies
* )
F17 Margin width Sets the initial value of the margin width for the margin copy
mode (see page 5-1).
* This setting item will not be displayed if the optional
memory board is not installed.
1 mm ~ 18 mm (6 mm * )
F18 Border width Sets the initial value of the border erase width for the Sheet
Erase or Book Erase in the border erase mode (see page
5-2).
* This setting item will not be displayed if the optional
memory board is not installed.
1: 6 mm *
2: 12 mm
3: 18 mm
F19 Layout (4 in 1) Sets whether to place the originals vertically or horizontally
for 4 in 1 layout copying (see page 5-4).
* This setting item will not be displayed if the optional
memory board is not installed.
1: Vertical (Z) *
2: Horizontal (N)
F20 Layout (borderline) Selects the type of borderline for layout copying (see page
5-4).
* This setting item will not be displayed if the optional
memory board is not installed.
1: None *
2: Solid line
3: Dotted line
F21 Transparency mode When coping onto transparencies or thick paper using the
multi-bypass, select the paper type using this setting. 1: Transparencies *
2: Thick paper