TA Triumph-Adler P-4030D - Manual (Page 148)

Operation Panel
4-88
PanelReset Timer (Setting the panel reset timer)
When Auto Panel Reset is set to On, this sets the time until the panel is automatically reset after the user stops using
the panel. The default setting is 90 seconds.
1
In the Timer Setting menu, press  or  to select PanelReset
Timer.
2
Press [OK]. The PanelReset Timer screen appears.
3
Use the numeric keys or press  or  to set the panel reset time.
4
Press [OK]. The panel reset time setting is stored and the Timer
Setting menu reappears.
Sleep Level Set. (Sleep level setting)
There are two sleep modes with different levels of sleep: Quick Recovery and Energy Saver.
Quick Recovery Mode: The recovery from the sleep mode is faster than when using Energy Saver mode.
Energy Saver Mode: This makes it possible to reduce energy consumption even further than with Quick Recovery mode.
With Energy Saver mode, you can set whether to enable the Energy Saver mode for each separate function.
1
In the Timer Setting menu, press  or  to select Sleep Level
Set..
2
Press [OK]. The Sleep Level Set. menu screen appears.
3
Press  or  to select Sleep Level.
4
Press [OK]. The Sleep Level screen appears.
5
Press  or  to select Quick Recovery or Energy Saver.
6
Press [OK]. The sleep level is set and the Sleep Level Set.
menu reappears.
When Energy Saver is set, next go on to set whether or not to use
Energy Saver mode for each function.
PanelReset Timer: a b
(5 - 495)
/90-sec.
Note For information on the Quick Recovery mode and Energy Saver mode, refer to Energy Saver Function on
page 2-21.
Sleep Level Set. menu is not displayed when the optional network interface kit (IB-50) or wireless network
interface kit (IB-51) has been installed.
Sleep Level Set.: a b
********************-
2 Status
[ Exit ]
1 Sleep Level
Sleep Level: a b
1 Quick Recovery
********************-
2 *Energy Saver
Sleep Level Set.: a b
********************-
2 Status
[ Exit ]
1 Sleep Level