RIGOL DS6000 Series - Manual (Page 39)

RIGOL
RP1003C/RP1004C/RP1005C User’s Guide V
Precautions
 To avoid short circuits and potentially life-threatening hazards,
never connect the current probe to a circuit that operates at
greater than the maximum rated voltage or over bare
conductors.
 When conductors being measured carry in excess of the safe
voltage level and not more than the maximum rated voltage,
to prevent short circuits and electric shock while the core
section is open, make sure that conductors to be measured
are insulated with material conforming to the requirements of
measurement category, working voltage and pollution degree.
 Isolate the output terminal of the probe from other terminals
on the measuring instrument using basic insulation
conforming to the requirements of measurement category,
working voltage and pollution degree.
 The core and shield case of the current sensor are not
insulated. Please do not use the current sensor on bare
conductors.
 Be careful to avoid damaging the insulation surface while
taking measurements.
 Please use the power supply provided with this product or
other power supply conforming to the specifications of this
product. Make sure that the power supply has a protective
earthing with double-insulation construction.
Core