RISCO Group ProSYS 128 - Manual (Page 33)

Access Control User's Manual 33
Configuring User Settings
6 6 8 8 CODE CODE # # 5 5
You can define settings for users of the system, including
assigning PIN (Personal Identification Number) codes, assigning
users to specific access groups, and deleting users, as described
in the following sections:
x Assigning PIN Codes, below
x Assigning Users to Access Groups, page 34
x Deleting Users, page 35
Assigning PIN (Personal Identification Number) Codes
6 6 8 8 CODE CODE # # 5 5 1 1
The PIN code option enables you to assign one PIN code to each
individual user, which is required if your system has readers with
keypads installed. The system automatically assigns a duress
code to each user's PIN code, which is one number after the
user's
PIN code (for example: PIN code = 1234; automatic duress
code = 1235). Therefore, you cannot assign sequential PIN codes
to users in the system. You must use every other number, for
example, 1234, 1236, 1238, and so on.
NOTES:
The PIN CODE must be defined after assigning a card to a user or else it will be
erased.
For users 00-98 it is recommended to use the same PIN code that was used in
your security system.
If you enter a sequential number by mistake, the following message is
displayed: PIN CODE FAILED
¾
To assign a PIN code:
1)
ACCESS CONTROL:
1) SETTINGS
ACCESS CONTROL:
1) SETTINGS
From the Access Control menu,
select
[5] User Settings.
2)
USER SETTINGS
1) PIN CODE
Select [1] PIN Code.