RISCO Group ProSYS 128 - Manual (Page 25)

Access Control User's Manual 25
NOTE:
In addition to the list of weekly programs that have been defined in the
system, the [99] Always (default) and [00] Never options are available.
5) Repeat steps 3 and 4 to define additional doors and
their associated weekly programs to the access
group, as required.
6)
ENTER GROUP NAME
After you have selected weekly
programs for the available doors, this
option is displayed. Enter a logical
name for the group and press
.
7)
ACCESS GROUP 01
IS DEFINED
ACCESS GROUP 01
IS DEFINED
This message indicates that the
access group has been defined
successfully.
Adding Users to the System
6 6 8 8 CODE CODE # # 4 4
The record users option enables you to add two types of users to
the system, as follows:
x Adding Arm/Disarm Users, page 26
x Adding Enter/Exit Users, page 29
NOTE:
This option is only enabled when the Access Control module is connected to the
security system.
When performing these procedures, use the data that you
prepared in Table 6: User Settings, page 43.
When a Code Entry Fails
When adding both types of users to the system, if the user
number has already been used, a message is displayed,
providing you with the option to overwrite the user data. In
addition, if the card code has already been used in the system,
a message is displayed, indicating that the card code exists,
followed by three beeps.