Precision Digital PD6400 - Manual (Page 79)

Model PD6400 High Voltage & Current Meter Instruction Manual
79
Meter Copy Function (Copy)
The Copy function is used to copy (or clone) all the settings from one
meter to other meters requiring exactly the same setup and
programming (i.e. type of input, scaling, decimal point, filter, bypass,
etc.).
Warning!
Only the PDA1200 meter copy cable must be used for
meter-to-meter interfacing.
Using standard CAT5 or other cable will cause
damage to both meters.
Meter Copy or Cloning Instructions
Caution!
Do not connect the two meters to
the same signal source while
cloning. Internal calibration may
be affected.
!
Copy Function Requirements
To successfully copy settings from one meter to another, both meters
must have the same software version and the same baud rate setting.
See Determining Software Version, page 83 for instructions.