Installation and assembly, Before start-up – MCZ Tube 2013 User Manual

Page 27

5-INSTALLATION AND ASSEMBLY

BEFORE START-UP

GENERAL PRECAUTIONS

Remove all components that could burn from the brazier and the glass (manual, various adhesive labels and any polystyrene).

Check that the brazier is positioned correctly and rests properly on the base.

After a long period of inactivity, remove any pellets left in the hopper (using a vacuum cleaner with a long pipe), as they

could have absorbed moisture, thereby altering their original characteristics and no longer being suitable for combustion.

The first start-up may not be successful as the feed screw is empty and does not always manage to load the required

amount of pellets in the brazier in time for the fire to be regularly ignited.

CANCEL THE FAILED START-UP ALARM STATUS BY BRINGING SELECTOR “D” TO OFF. REMOVE THE PELLETS FROM THE

BRAZIER AND REPEAT START-UP. (SEE THE "SAFETY DEVICES" PARAGRAPH)

If a flame does not ignite after a number of failed start-ups, even though the pellet supply is correct, make sure the brazier

is set in place correctly, which must be interlocked in its seat and clean from any ash deposits. If no anomaly is found during this

inspection, there may be a problem with the product components or installation may not be correct.

REMOVE THE PELLETS FROM THE BRAZIER AND CONTACT AN AUTHORISED TECHNICIAN.

Avoid touching the stove during the initial start-up, as the paint hardens during this phase. If you touch the paint,

the steel surface may be exposed.

If necessary, touch up the paint with the spray can of the specific colour. (See "Pellet stove accessories")

This manual is related to the following products: