MCZ Tube 2013 - Manual (Page 26)

24
5-INSTALLATION AND ASSEMBLY
ASSEMBLING/REMOVING THE AIR
FILTER
OPENING/CLOSING THE DOOR
ELECTRICAL CONNECTION
First connect the power cable on the rear side of the stove and then to a wall socket.
The main switch on the rear side must only be activated when the stove is used; otherwise, it is advisable to keep it off.
It is recommended to disconnect the power cable when the stove is not used.
ASSEMBLING THE AIR FILTER
The cylindrical filter is already fitted inside the stove.
If it must be cleaned, slightly loosen the screw knob on the air inlet pipe, remove the filter, clean it and then set it and block it in place by
tightening the knob.
ATTENTION!
The stove must never be operated without the air filter. The manufacturer cannot be held liable for any damage
caused to the internal components if this requirement is not complied with.
OPENING/CLOSING THE DOOR
The door is opened by inserting the cold handle on the opening hook of the door, lifting and pulling.
ATTENTION!
The door must be closed properly for the stove to work correctly.