Extron Electronics CVEQ 100 Series - Manual (Page 5)

CVEQ 100 and SVEQ 100 Series • Quick Start Guide
Quick Start — CVEQ/SVEQ 100 Series, cont’d
QS-2 TOC-i CVEQ 100 and SVEQ 100 Series • Table of Contents
Table of Contents
Chapter One • Introduction ................................................... 1-1
About this Manual .................................................................... 1-2
Features ........................................................................................ 1-2
Chapter Two • Installation ..................................................... 2-1
Application Examples ............................................................... 2-2
Installation Instructions ........................................................... 2-4
Installing the CVEQ 100/SVEQ 100 ....................................... 2-4
Mounting the CVEQ 100 and SVEQ 100 ................................2-4
Tabletop use ............................................................................2-4
UL rack mounting guidelines .................................................2-4
Rack mounting ........................................................................2-5
Furniture mounting — under-desk........................................2-7
Furniture mounting — through-desk (CVEQ 100 only) .......2-7
Back of the rack mounting (SVEQ 100 only).........................2-9
Installing the CVEQ 100 AAP/SVEQ 100 AAP ..................... 2-11
Installing the CVEQ 100 MAAP/SVEQ 100 MAAP .............. 2-12
Mounting in an external wall box ......................................2-12
Mounting in a European cable channel ..............................2-13
Installing the CVEQ 100 D/SVEQ 100 D .............................. 2-14
Preparing the site and installing the wall box ...................2-14
Mounting the line driver .....................................................2-15
Testing and troubleshooting ............................................... 2-16
If the image does not appear or there is no sound ...........2-16
If the image is not displayed correctly ................................2-17
Chapter Three • Operation ..................................................... 3-1
Front Panel Features and Operation ................................... 3-2
Rear Panel Features and Operation ..................................... 3-6
Power supply wiring ............................................................ 3-11
Gain adjustment control ...................................................... 3-12
Equalization (EQ) adjustment control ................................ 3-12
Replacing the Decora Faceplate (CVEQ 100 D and
SVEQ 100 D)
............................................................................... 3-13
Appendix A • Specifications, Part Numbers, and
Accessories ........................................................................................A-1
Specifications ..............................................................................A-2
Included Parts .............................................................................A-7
Optional Accessories ................................................................A-9
When using long cables, follow these steps:
a
. Supply the color bars test signal to the input. (Recommendation:
use an Extron VTG 300 Video Test Generator to generate the test
signal.)
b . Adjust the Gain control(s) for the output until the signal level
at the far end is the same as the input (or the display shows the
correct brightness and contrast).
c . Adjust the EQ control for the output so that no overshoot or
round front corner appears at the far end on the oscilloscope or
you see a sharp picture with no smearing.
Step 7
See "Installation Instructions" in chapter 2 for further installation
details.