Extron Electronics CVEQ 100 Series - Manual (Page 21)

CVEQ 100 and SVEQ 100 Series • Operation
Operation, cont’d
3-10 CVEQ 100 and SVEQ 100 Series • Operation 3-11
Tip (+)
Sleeve ( )
Ü
Video output connector — Connect a composite video output
device to this female BNC connector.
á
S-video Y connector (luma, white cable) — Connect the luma of
an S-video output device to this female BNC connector.
S-video C connector (chroma, yellow cable) — Connect
the chroma of an S-video output device to this female BNC
connector.
e
Audio output connector — Wire a balanced/unbalanced audio
output device to this 3.5 mm, 5-pole, direct insertion captive
screw connector. See the following wiring diagrams.
N Balanced audio is more resistant to noise and can be driven
for longer distances than unbalanced audio. For best
results, wire the output for balanced audio.
Balanced Stereo
Sleeve (s)
Left Tip (+)
Left Ring (-)
Right Tip (+)
Right Ring (-)
Set Audio Out switch to Stereo.
Balanced Mono
Sleeve
Tip (+)
Ring (-)
Unbalanced Stereo
Sleeve
Left Tip (+)
Right Tip (+)
Use either the left or the right channel.
Unbalanced Mono
Sleeve
Tip (+)
Use either the left or the right channel.
Set Audio Out switch to Dual Mono. Set Audio Out switch to Dual Mono.
Set Audio Out switch to Stereo.
Do not tin the wires!
CAUTION Connect the sleeve to ground
(Gnd). Connecting the sleeve to
a negative (–) terminal will
damage the audio output
f
Output equalization (EQ) potentiometer — Use an Extron
Tweeker (a small screwdriver) to rotate this control to adjust
equalization when the line driver is connected to long output
cables. The adjustment range is 0 dB to +7 dB. The default is
set to 0 dB (the dot position). See "Equalization (EQ) adjustment
control" in this chapter.
g
Output gain potentiometer (luma) — Use an Extron Tweeker
(a small screwdriver) to rotate this control to adjust the CVEQ's
gain or the SVEQ's luminance gain when the line driver is
connected to long output cables. The adjustment range is
-1 dB to +3 dB. The default is unity (the dot position). See
"Gain adjustment control" in this chapter.
h
Output gain potentiometer (chroma) — Use an Extron Tweeker
(a small screwdriver) to rotate this control to adjust the SVEQ's
chrominance gain when the line driver is connected to long
output cables. The adjustment range is 0 dB to +10 dB. The
default is unity (the dot position). See "Gain adjustment control"
in this chapter.
i
Audio output select switch — Use this switch to select either
stereo (up) or dual mono (down) output. When set for dual
mono, the left and right channels output the same signal (either
channel or both channels can be used). The audio output can
be wired for balanced/unbalanced mono or stereo output. The
wiring and the switch setting must match.
Power supply wiring
Wire the line driver's power connector as shown below.
N The CVEQ 100 and SVEQ 100 use a pre-wired captive
screw power connector. The D, AAP, and MAAP models
use direct insertion connectors.
Power Supply
Output Cord
SECTION A–A
Ridges
Smooth
A A
Captive Screw
Connector
3 5
Power connector wiring