Extron Electronics CVEQ 100 Series - Manual (Page 10)

CVEQ 100 and SVEQ 100 Series • Installation
Installation
CVEQ 100 and SVEQ 100 Series • Installation 2-6 2-7
Furniture mounting — under-desk
To mount the line driver under furniture, use the optional
VersaTools under-desk mounting kit for the SVEQ 100
(Extron MBU 123, part #70-212-01) or the optional under-desk
kit for the CVEQ 100 (Extron MBU 125, part #70-077-01).
QuarterRackUnderdeskMounting
Under-desk mounting kit
part # 70-212-01
Under-desk mounting kit
part # 70-077-01
Preparing the line driver for under-desk mounting
1 . If rubber feet were previously attached to the bottom of the
unit, remove them.
2 . Attach the mounting brackets to the line driver with the
provided machine screws as shown in the previous figure.
3 . Hold the unit with the attached brackets against the
underside of the table or other furniture. On the mounting
surface, mark the location of the bracket’s screw holes.
4 . Drill ³⁄³²" (2 mm) diameter pilot holes, ¼" (6.3 mm) deep in
the mounting surface at the marked screw locations.
5 . Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until slightly less
than ¼" of the screw head protrudes.
6 . Align the mounting screws with the slots in the brackets
and place the unit against the surface, with the screws
through the bracket slots.
7 . Slide the unit slightly forward or back, then tighten all four
screws to secure it in place.
8 . Attach input and output cables. See chapter 3.
Furniture mounting — through-desk
(CVEQ 100 only)
To mount the CVEQ 100 through furniture, use the optional
VersaTools through-desk mounting kit (Extron MBD 129,
part #70-077-02), as follows.
Use 2 mounting holes on
opposite corners.
(2) 4-40 x 3/16"
Screws
1U Universal Rack Shelf
Both front false faceplates
use 2 screws.
QuarterRackStandardShelf
1/4 Rack Width Front False
Faceplate
1/2 Rack Width Front False
Faceplate
Mounting the line driver on a standard rack shelf
6" Deep Rack Shelf
Front false
faceplate
uses 2
screws.
1/2 Rack Width Front False
Faceplate
Use 2 mounting holes on
opposite corners.
(2) 4-40 x 3/16"
Screws
Mounting the line driver on a 6-inch rack shelf