Sealey VS715 - Manual (Page 2)

3
Provide appropriate lubrication while cutting threads.
1. Remove the wheel axle nut. (Refer to fig.1).
2. Choose the correct diameter and pitch thread chaser
from the set.
3. Screw the thread chaser onto the axle spindle, ensure
the thread chaser is the correct way around (Fig.2)
face towards the thread. Note: the face is the side
without the embossed writing.
4. When chasing a thread, turn ½ turn clockwise, then ¼
turn anti-clockwise and so on, this will allow the swarf
to flow into the grooves of the chaser.
5. Chase the entire thread in this manner.
6. When complete, remove the thread chaser.
7. Clean the axle thread and thread chaser with paraffin
or similar to completely remove all traces of swarf.
3. INSTRUCTIONS Fig.1
Fig.2
M24X1.50
SEA
LEY
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and
component parts without prior notice. IMPORTANT: No liability is accepted for incorrect use of product. WARRANTY: Guarantee
is 12 months from purchase date, proof of which will be required for any claim. INFORMATION: For a copy of our latest
catalogue and promotions call us on 01284 757525 and leave your full name and address including postcode.
Original Language Version
VS715.V2 Issue: 1 - 04/12/13 © Jack Sealey Limited
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
W e b
email
Environmental Protection.
Recycle unwanted materials instead of disposing of them as waste.
All tools, accessories and packaging should be sorted, taken to a recycle
centre and disposed of in a manner which is compatible with the environment.