Sealey VS715 User Manual

Sealey Tools

INSTRUCTIONS FOR:

CV JOINT THREAD CHASER 8pc

MODEL No.

VS715.V2

1.1. GENERAL SAFETY
p

WARNING! Ensure health & safety, local

authority, and general workshop practice

regulations are adhered to when using this

equipment.
8

DO NOT hold the workpiece by hand.

Use clamps or a vice (not included) to secure

the workpiece.

Wear approved safety eye protection

(standard spectacles are not adequate).

Keep the work area clean, uncluttered and

ensure there is adequate lighting.

Keep children and unauthorised persons

away from the working area.

1.2. PERSONAL PRECAUTIONS
3

Remove ill fitting clothing. Remove ties,

watches, rings, and other loose jewellery,

and contain and / or tie back long hair.

Ensure that a vehicle which has been jacked

up is adequately supported with axle stands

and that the wheels are chocked.



DO NOT use air tools.

Repairs light damage to CV joint threads. Set contains sizes to fit the most common types of

vehicle. Must be used with a light oil to lubricate thread. Supplied in storage case.

1. SAFETY INSTRUCTIONS

2. INTRODUCTION & SPECIFICATION

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these

instructions and properly maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL

REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE

PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL

INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.

Contents:

M20 x 1.25, M20 x 1.5, M22 x 1, M22 x 1.5, M24 x 1.5, M24 x 2mm.

(UNEF - Extra Fine Pitch) 3/4” x 20 UNEF, 13/16” x 20 UNEF.

ALWAYS KEEP THREADS

WELL LUBRICATED WITH A LIGHT

OIL.



DO NOT USE AIR TOOLS

M24X1.50

SEALEY

Original Language Version

VS715.V2 Issue: 1 - 04/12/13