Sealey VSE5580 - Manual (Page 2)

Fig.5
3.1.2. Using a 24mm spanner, turn the nut clockwise. The extractor
will start to extract the bush through the housing (Fig.3).
3.1.3. Keep turning until the bush has been extracted all the way out
of the housing. Take care as the bush and assembly will fall
away when the bush is fully removed.
NOTE! If any undue resistance is felt, remove the assembly and
check everything is correctly aligned. The bush will only push out
in one direction.
3.2. Installing new bush.
3.2.1. Before installing a new bush, clean the inside of the housing.
3.2.2. Assemble the silver disc Adaptor (D) on the threaded rod, with
internal boss adjacent to shoulder, orientation as in Fig.4 - viewed
from below. Pass the bolt through the housing from the top,
through the presented bush and then position the silver disc
Adaptor (C) over the bolt with the internal boss uppermost , fitting it
against the bush.
To facilitate correct positioning of the bush, the installation
Adaptor (C) has a boss and recess that align with the face of
the new bush. The bush should then be aligned in the
housing so that the bush is facing directly upwards (Fig.4).
Thread the ball race nut (E) onto the bolt and wind it up to the
adaptor. Check to make sure that everything is aligned on the
housing axis and that the bush is sitting squarely against the
housing machined face.
3.2.3. Using a 24mm spanner, turn the nut clockwise. The bush will
start to enter into the housing (Fig.4)
NOTE! If any undue resistance is felt, remove the assembly
and check that everything is correctly aligned.
3.2.4. Continue to turn the nut to install the bush, when the bush is
fully seated, solid resistance will be felt and the bush is now
fully installed (Fig.5).
3.2.5. Disassemble the tool, clean and lubricate before returning the
parts to the storage case.
3.2.6. Re-fit all the components as per the vehicle manufacturer’s
service instructions or a proprietary manual.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version VSE5580 Issue: 1 - 22/10/12
01284 757500
01284 703534
[email protected]
www.sealey.co.uk
email
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or phone 01284 757500.
© Jack Sealey Limited
Fig.3
NEW FLANGED BUSH
Composite section through housing boss (4 places)
F
E
C
D
Fig.4
D
E
C
New bush
F
Section through
housing boss (4 places)