Fig.5 – Sealey VS7023A User Manual
Page 3
Original Language Version
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
VS7023A Issue No.1 - 14/11/12
Fig.5
4.2.5 Using the appropriate size ring spanners for the
force screw nuts, gradually tighten the force
screw nuts to drive the bush/bearing into the
housing. Ensure that the bush/bearing is square
to the housing during installation.
DO NOT use
air tools to operate the force screw nuts.
DO NOT
apply more than 150Nm torque to the force screw
nuts.
4.2.6 Once the bush/bearing has been successfully
installed, clean the components used and return
them to the carry case.
4.3 Using with a workshop press
4.3.1 Where in-situ access isn't possible, the end plates
and sleeves can be used with a standard
workshop press for bush/bearing removal and
installation. To avoid damage to the end plates,
it is recommended to use mild steel packing
between the press and the end plate during
workshop press operation.
Parts support is available for this product.
To obtain a parts list and diagram please log on to www.sealey.co.uk, email [email protected] or phone 01284
757500
© Jack Sealey Limited