Sealey VS0033 User Manual
Cooling system pressure testing kit, Vs0033, Model n
WARNING! Ensure Health & Safety, local authority and general workshop practice regulations are adhered to when using
this equipment.
Read instructions thoroughly to ensure safe and effective use.
Important! Read instructions in conjunction with
vehicle or equipment manufacturer's workshop manual.
Maintain the apparatus in good condition (use an authorised service agent). Before each use check condition of each
component. If any component is damaged, replace immediately. Use genuine parts only. Unauthorised parts may not
function correctly and will invalidate the warranty.
Use in a suitable work area. Keep area free from unrelated materials and ensure that there is adequate lighting.
WARNING! Always wear approved eye (or face) and hand protection when pressure testing.
Keep children and unauthorised persons away from the working area.
DO NOT operate the pressure tester when you are tired or under the influence of alcohol, drugs or intoxicating
medication.
DO NOT clean the equipment with solvents or other harsh chemicals.
DO NOT use the pressure tester for any purpose other than that for which it is designed.
When not in use return parts to the case, and store it in a safe, dry, childproof location.
INSTRUCTIONS FOR:
COOLING SYSTEM
PRESSURE TESTING KIT
MODEL N
O
:
VS0033
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly
maintained, give you years of trouble free performance.
1. SAFETY INSTRUCTIONS
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/
OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
2. DESCRIPTION
Capless tester uses cone adaptor system to seal and pressurise the cooling system. Adaptors may be used to replace both screw
and bayonet type cap fittings. The kit includes a pump with a pressure gauge and four system adaptors for use on a wide range of
vehicle applications.
Original Language Version
VS0033 Issue: 1 - 25/09/12
© Jack Sealey Limited
4. CONTENTS
VS0033.01
VS0033.02
VS0033.04
VS0033.03
Quick coupler
Pump plunger
Pressure relief valve
Pressure gauge 0-35psi (0-2.5bar)
VS001.V3-P
VS001.V3-P
Flexible hose
3. TECHNICAL SPECIFICATIONS
Part No Cone adaptor sizes
VS0033.01 17.0mm to 24.0mm
VS0033.02 28.0mm to 31.5mm
VS0033.03 37.0mm to 39.5mm
VS0033.04 47.0mm to 48.5mm