Sealey SMS2003 User Manual
Page 2
2. INTRODUCTION & SPECIFICATIONS
WARNING! Keep away from the grinding wheel when it is turning, and make sure no one is standing close in the line of the grinding wheel
trajectory.
DO NOT allow untrained persons to operate the saw blade sharpener.
DO NOT get the machine wet, or use in damp or wet locations or areas where there is condensation.
WARNING! DO NOT use the saw blade sharpener where there are flammable liquids, solids or gases such as paint solvents and including waste
wiping rags etc.
DO NOT operate the saw blade sharpener if any parts are missing or damaged as this may cause failure and/or personal injury.
DO NOT operate the saw blade sharpener when you are tired or under the influence of alcohol, drugs or intoxicating medication.
When not in use switch off the saw blade sharpener and remove the plug from the power supply.
Suitable for sharpening TCT saw blades ranging from Ø90 to Ø400mm. Fitted with a Ø100mm diamond coated grinding disc for optimising
saw blade performance. Precision 0-25° angle adjustment allowing each tip to be sharpened exactly the same. Quick and easy to use, whilst
saving money on having to constantly buy new blades.
Specifications:
Model No: . . . . . . . . . . . . . . . . . . . SMS2003
Motor Power: . . . . . . . . . . . . . .110W - 230V
Free Speed: . . . . . . . . . . . . . . . . . . 5300rpm
Wheel Diameter:. . . . . . . . . . . . . . . . 100mm
Minimum Blade Diameter: . . . . . . . . . 90mm
Maximum Blade Diameter:. . . . . . . . 400mm
Angle Adjustment: . . . . . . . . . . . . . . . . 0-25°
Weight: . . . . . . . . . . . . . . . . . . . . . . . . . . 5kg
3. CONTENTS
Unpack the product and check the contents. Ensure that there is no damage. If any problem is noted, contact your supplier immediately.
Original Language Version
© Jack Sealey Limited
SMS2003 Issue: 1 27/02/14
4. OPERATION
before sharpening saw blades ensure that you wear approved safety goggles, ear defenders, and safety gloves. All safety
instructions in Section 1 must be followed.
WARNING! Always ensure that the machine is switched off before connecting the plug to the socket and always disconnect before
carrying out any work on the machine.
4.1.
Remove the knob, all washers, the spring and the centring piece from the saw blade holder.
4.2.
Put the saw blade (which needs to be sharpened), on the bolt and reassemble in the order indicated on the picture below. (See fig.2).
Fig.1
4.3.
The saw blade only needs to be centred but not tightly fixed. Screw down the fastening knob only as much as necessary for sufficient
tension, so that the saw blade can still be turned. Make sure that the centring piece is not slanted. (See fig.2).
Fig.2