Technical specifications 2. description, Content – Sealey GDM200F/VS User Manual
Page 2
others in the workplace should keep a safe distance from the drill, especially when it is in operation.
Keep the work area as childproof as possible by using padlocks and master switches.
Keep drill bits clean and sharp for best and safest performance. follow the instructions for lubrication and changing accessories.
remove ill fitting clothing. remove ties, watches, rings and other loose jewellery and contain long hair.
Locate drill in a suitable work area and keep area clean and tidy and free from unrelated materials. Ensure that there is adequate lighting.
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
secure unstable workpieces with a clamp, vice or other adequate holding device.
Avoid unintentional starting.
DO NOT use the drill for a task that it is not designed to perform.
DO NOT allow untrained persons to operate the drill.
DO NOT get the drill wet or use in damp or wet locations or areas where there is condensation.
DO NOT operate the drill if it is damaged.
DO NOT use drill in an area where paint fumes, solvents or flammable liquids pose a potential hazard. Keep flammable material away from
the drill when operating. flammable waste, such as wipes or cleaning rags, must be placed in a closed metal container and disposed of correctly.
DO NOT exceed the rated capacity of the drill.
DO NOT operate the drill if any parts are missing as this may cause failure and/or personal injury.
DO NOT leave the drill operating unattended.
DO NOT operate the drill when you are tired or under the influence of alcohol, drugs or intoxicating medication.
DO NOT pull the cable from the power supply.
When not in use switch off the drill, remove the plug from the power supply and do not leave until the chuck has come to a complete stop.
3. TECHNICAL SPECIFICATIONS
2. DESCRIPTION
these variable speed drills are suitable for light industrial, agricultural and woodworking applications. Both drills are fitted with flip-up safety
guards and “no-Volt release” switches which prevent accidental restart after a mains power interruption. A rack and pinion feed shaft with
preset depth control for repetitive work is also included. Work clamps, vices and mortising attachments are available for these drills, contact
your local sealey dealer for information.
4. CONTENT
4.1. Package content
unpack the parts listed below and check to ensure they are in good condition. Any queries must be reported to your dealer immediately.
Head Assembly
feed Handles and Knobs (3)
speed control Handle
column with flange
Pivoted Lock Handle (2 - table arm & bracket)
safety Guard
Base
Adjusting Handle with set screw (table)
set screws (2 - head)
table
Bolt and Washer (table arm)
screw and Washer (pulley cover)
table Arm
Bolts (4 - column)
Wedge
table Bracket and Worm
chuck and Key
Hex. Keys (2)
rack and rack ring
Arbor
Original Language Version
MODEL No:
GDM200f/Vs
Drilling Capacity (Chuck Size):
16mm
Spindle Nose Taper:
Mt2
Swing:
436mm
Spindle centre to column:
178mm
Spindle travel:
80mm
Number of speeds:
Variable
Speed range:
150-2300rpm
Maximum Distance Spindle to Table:
800mm
Maximum Distance Spindle to Base:
1230mm
Working Table Surface size:
Ø310mm
Working Base Surface size:
205 x 205mm
Overall Base Size:
460 x 275mm
Column diameter:
80mm
Collar diameter:
60mm
Overall Height:
1630mm
Motor Power:
450W - 230V
Input Power:
650W - 230V
Weight:
81kg
Optional Keyless Chuck 16mm:
GDMX/KC
GDM200f-Vs Issue no.1 27/02/12