Operation, Maintenance – Sealey SM3002DFD User Manual
Page 4
5.
OPERATION
The lathe may now be operated as before, but with the accuracy and convenience of digital measurement.
There are three buttons present on each display:
In/mm
Switches display between inch and mm.
ON/OFF Turns the unit on or off.
ZERO
Sets the display to 0.
5.1 Turn both displays on by pressing the ON/OFF button on each one.
5.2 Select the required unit of measurement for each display, using the In/mm buttons.
5.3 Set up the lathe as required and zero the displays using the ZERO buttons (the displays can be reset to 0 at any time)
5.4 When you are finished working on the lathe, turn both displays off by pressing the ON/OFF button on each one.
6.
MAINTENANCE
6.1
The SM3002DFD requires little by way of maintenance. Keep the displays clean by occasionally wiping with a moist cloth - DO NOT use
solvents or abrasives.
6.2 Should the display begin to fade during use, the batteries must be replaced. Each display requires one LR44 battery.
6.2.1 Remove the two screws (fig 21a) and the battery compartment cover (fig 21b)
6.2.2 Gently pull the yellow tag to eject the battery.
6.2.3 Insert a new battery (type LR44) into the battery compartment, with the positive (+) side facing up towards the LCD.
fig 21
fig 22
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: Call 01284 757525 for our catalogue & promotions. Leave your full name, address & postcode.
Sole UK Distributor,
Sealey Group, Bury St. Edmunds, Suffolk.
01284 757500
www.sealey.co.uk
01284 703534
Web
SM3002DFD - 1 - 100504
a
b