Sealey WRP1600 - Manual

INSTRUCTIONS FOR:
WIRE ROPE PULLERS
Models:
WRP800, WRP1600, WRP3200
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
WRP800, WRP1600, WRP3200 - 2 - 180806
1. SAFETY INSTRUCTIONS
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
2. INTRODUCTION & SPECIFICATIONS
! Familiarise yourself with the application, limitations and potential hazards of the puller.
" WARNING! Pullers are not designed or certificated for lifting or slinging loads. They are intended only as pulling/tensioning devices
and must only be used as such, and with care.
! Ensure the puller is maintained in a safe working condition. Inspect the cable regularly. Check for fraying, kinks, broken strands or
distortion. If any fault is found, replace the cable using a genuine replacement from your authorised service agent. Check all component
parts, do not use if damaged but contact an authorised service agent.
" WARNING! Ensure you know how much load you are pulling. Never exceed the maximum pulling capacity. Take into account
any angle of incline over which the load must be pulled. Also account for pulling loads from thick mud, or through snow or
water. Chock the wheels of vehicles to be winched and only then release any brakes and place gears in neutral. Ensure the load
is capable of free movement before pulling. Take up the strain on the puller before removing the wheel chocks from a vehicle.
! If necessary fit an adequate sling, eyebolt or other accessory to the load. Ensure that accessories are equal to, or exceed maximum capacity of puller.
! Maintain correct balance and footing whilst using the puller.
! Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery and contain and/or tie back long hair.
! Wear appropriate safety clothing, gloves and eye protection.
! Keep children and non-essential persons away from the operating area. Be aware of the location of other persons assisting you.
! Take necessary precautions for your personal safety whilst using the puller.
# DO NOT operate the puller if any parts are damaged or missing as this may cause failure and/or personal injury.
# DO NOT feed the rope from the rear of the puller.
# DO NOT operate the release lever while the puller is under load.
# DO NOT operate both levers at the same time.
# DO NOT work behind a load that is under tension, always use additional methods to secure load.
" WARNING! DO NOT exceed the maximum pulling capacity.
" WARNING! DO NOT use the puller as a lifting device. DO NOT use the puller for any purpose other than that for which it is designed.
# DO NOT pull the cable over or around a corner.
# DO NOT wrap cable around any object or hook the cable back on to itself.
$ DANGER! DO NOT use a “cheater” pipe, lever, or other device to lengthen the handle for additional leverage, as the puller may fail,
causing damage and/or personal injury.
# DO NOT operate the puller if you are tired or under the influence of alcohol, drugs or intoxicating medication.
# DO NOT move the handle abruptly when releasing the tension from the load.
NOTE: Use caution when carrying these pullers as the units are heavy.
! Keep the puller clean and store in a safe, dry, childproof location when not in use.
These hand operated pullers are ideal for moving vehicles,
logs, machines and other heavy objects. All models feature
two levers for extra control when pulling or releasing load.
Added quick release lever saves time when tightening the
rope to required length. All units are GS/TUV approved.
Supplied with removable lever handle and 20m of wire rope
with heavy-duty hook.
SPECIFICATIONS
Model: . . . . . . . . . .WRP800 . . .WRP1600 . . .WRP3200
Pulling capacity . . . .800kg . . . . . .1600kg . . . . .3200kg
Wire rope Ø . . . . . . .8.3mm . . . . .11mm . . . . . .16mm
Wire rope length . . . .20m . . . . . . .20m . . . . . . .20m
Weight . . . . . . . . . .6.4kg . . . . . .12kg . . . . . . .23kg
Note: Pulling capacity is given as a rolling load on
a level surface. Exercise extreme caution and do
not overload, particularly on “deadweight” loads.