Sealey S0530 - Manual (Page 3)

 WARNING! Ensure the grinder is disconnected from the mains
power supply before attempting any maintenance.
6.1.
Cleaning
Keep the grinder ventilation slots clean and free from
obstructions. If available, blow compressed air into the
vents to clear any internal dust (safety goggles must be
worn when undertaking this process). Keep the outer case
of the grinder clean and free from grease.
Do not wash with water or use solvents or abrasives.
 WARNING! This tool is not intended for continuous professional use.
 WARNING! Ensure grinder is unplugged from the mains power supply before changing accessories.
5.1. Preparation
5.1.1. Assemble grinding disc according to section 3.1. and position handle to suit the task.
5.1.2. Ensure the disc safety guard is correctly positioned.
5.1.3. Plug grinder into the mains power supply.
5.2. Grinder On/Off Switch
the on/off switch (fig 6.1) is designed to avoid starting should the switch be pressed in error.
5.2.1. once plugged into the mains supply, start the grinder by sliding the switch forward - it will latch in the ‘on’ position.

WARNING! When the grinder first starts it will kick to the right, you must ensure therefore that the tool is securely gripped in both
hands. Especially important is the position you choose to secure the auxiliary handle in order to maintain stability.
5.2.2. to switch off the machine push the back of the on/off button down. the button will slide backward under spring pressure to the safety
position and the machine will stop.
 WARNING! Before grinding ensure you wear approved safety goggles, ear defenders, dust mask if grinder generates dust
and safety gloves, and that all other safety instructions in Section 1 are followed carefully.
5.3. Grinding
the key to effective operating is controlling the pressure and surface contact between the disc and the workpiece.
 WARNING! DO NOT switch the grinder on whilst the disc is in contact with the workpiece. Bring the rotating disc to the workpiece.
5.3.1. Allow the disc to reach full speed before starting to grind.
5.3.2. Grind flat surfaces at an angle of between 10 and 20°.
too great an angle will cause a concentration of pressure in one small area resulting in gouging or burning of the surface.
5.3.3. When grinding is complete allow the workpiece to cool. Do not touch the hot surface.
5.3.4. unplug the grinder from the mains power supply, clean and store in a safe, dry, childproof area.
5. OPERATING INSTRUCTIONS
 WARNING! DO NOT USE DISCS THAT ARE DAMAGED, OR SUSPECTED OF DAMAGE.
Before using a grinding disc ensure there are no fissures or cracks. once mounted on the grinder test the disc before use by facing the grinder
in a safe direction (pointing away from yourself, others and vulnerable items) and operate for a short time.

DANGER! Use of damaged discs may cause damage and/or personal injury.
Grinding and cutting discs used in association with this machine shall be of an adequate speed rating and suitable for the job in hand.
the discs should be manufactured in accordance with British standard 4481:Part 1 1989.
only persons holding a grinding wheel certificate are authorised to change grinding discs.
4. GRINDING DISCS
6. MAINTENANCE
fig.6
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this equipment. WARRANTY: Guarantee 12 months from purchase date, proof of which will be required for any claim.
Sole UK Distributor, Siegen Tools, Sealey Group,
Kempson Way, suffolk Business Park, Bury st. Edmunds, suffolk, IP32 7Ar
[email protected]
Original Language Version s0530.V2, s0685.V2 Issue: 2 - 16/02/10
email