Sealey SMS10 - Manual (Page 5)

6. mAINTENANCE
WARNING! Ensure machine is switched off and plug is removed from socket before any maintenance is undertaken.
6.1 Regularly clean the saw to remove dirt, dust and chips, using a brush and cloths, and re-oil moving parts. if compressed air is
used for cleaning remember to wear protective goggles and keep other personnel at a safe distance.
6.2 CARBON BRUSHES
6.2.1 The carbon brushes should last for approx. 50 hours of running time. Replace when there is less than 5mm of carbon remaining.
6.2.2 The brushes are located on either side of the motor.
6.2.3 Undo the plastic cap and withdraw the brush, use caution as the brushes are spring loaded. Repeat on the other side.
6.2.4 Reassemble by reversing the procedure.
6.3 Ensure that motor vents are clear at all times.
6.4 Clean plastic components with water and detergent, never use caustic or abrasive cleaners.
6.5 Check the condition of the blade before every use, any sign of damage should result in the blade being disposed of and a new
replacement fitted. Ensure the replacement blade conforms to the saws specifications i.e RPM, outer blade diameter and type
i.e woodcutting.
6.6 Listen to the saw when in use. if any unusual sounds are heard stop the machine and inspect . if in any doubt refer the
machine to an authorised service agent.
6.7 if the laser does not function remove the battery cover and replace the batteries (2 x AAA).
mITRE BEVEL COmpOUND
mitre Cut
To perform a mitre cut loosen the mitre lock
(6) position the saw table to the desired
angle and tighten the mitre lock(6).
For wide workpieces loosen slide lock (11),
bring the blade down and slowly move the
blade backwards until the cut is complete.
DO NOT stand in front of the blade, keep to
one side.
Bevel Cut
To perform a bevel cut position the blade to
the desired angle using the bevel lock (14).
For wide workpieces loosen slide lock (11),
bring the blade down and slowly move the
blade backwards until the cut is complete.
DO NOT stand in front of the blade, keep to
one side.
Compound Cut
To perform a compound cut select the
desired mitre and bevel cut position as
described in “Mitre Cut & Bevel Cut”.
For wide workpieces loosen slide lock (11),
bring the blade down and slowly move the
blade backwards until the cut is complete.
DO NOT stand in front of the blade, keep to
one side.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
ImpORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORmATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
iP32 7AR
www.sealey.co.uk
Web
email
Original Language Version SMS8, SMS10, SMS12 issue: 2 - 22/03/10