Sealey SA356 - Manual (Page 3)

4.1. Unpack the product and check contents against the parts
listed below. If there is anything damaged or missing contact
your supplier immediately.
Contents: SA356 Belt Sander, Sanding Belt and Hex. Key.
 WARNING! Ensure that you have read and
understood and then apply the safety instructions in Section 1.
4.2. Loosening the slider bolt on the underside of the sander allows the
slider to move closer to/further away from the idle pulley, tightening the belt
to suit the job in hand. After adjustment retighten the slider bolt.
4.3. Once connected to the air supply the sander is started by squeezing the trigger (E).
4.4. To remove and replace the sanding belt:
4.4.1 Ensure air-line is detached from the unit.
4.4.2 Release metal clip (F) retaining the pulley cover (A).
4.4.3 Press and hold spring-loaded latch (B), whilst pulling the idle pulley (C) inwards, towards the
drive pulley (D). once compressed, release the latch (B), ensuring it is engaged.
4.4.4 Replace/fit new sanding belt, close the pulley cover and release the spring loaded latch (B), being
careful of fingers or lose items.
4.5. The tracking of the belt can be altered by the adjusting bolt closest to the idle pulley on the opposite side.

WARNING! Disconnect sander from air supply before changing accessories, servicing or performing
maintenance. Replace or repair damaged parts. Use genuine parts only. unauthorised parts may be
dangerous and will invalidate the warranty.
5.1. If the system does not have an oiler, lubricate the air sander daily with a few drops of good grade air tool
oil such as Sealey ATO/500 or ATO1000, dripped into the air inlet (8) before use.
5.2. Clean the sander after use and change belts when required.
5.3. Loss of power or erratic action may be due to the following:
a) Excessive drain on the air line. Moisture or restriction in the air pipe. Incorrect size or type of hose
connectors. To remedy check the air supply and follow instructions in chapter 3.
b) Grit or gum deposits in the sander may also reduce performance. If your model has an air strainer
(located in the area of the air inlet), remove the strainer and clean it. Flush the sander out with gum
solvent oil or an equal mixture of SAE No 10 oil and kerosene. Allow to dry before use.
If you continue to experience problems, contact your local Sealey service agent.
5.4. For a full service contact your local Sealey service agent.
5.5. When not in use, disconnect from air supply, clean sander and store in a safe, dry, childproof location.
4. OPERATING INSTRUCTIONS
5. MAINTENANCE
fig 3
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
email
Original Language Version
SA356 Issue: 3(SP) - 15/10/13 © Jack Sealey Limited
Environmental Protection.
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and
disposed of in a manner which is compatible with the environment.