Troubleshooting – Sealey SA316 User Manual
Page 3
PROBLEM
CAUSE
REMEDY
Rivet jammed.
Wrong size rivet/nozzle.
Filings jammed in jaw housing.
Filings jammed in nozzle.
Use the correct size nozzle for the rivet
Snap off rivet head, dismantle jaw housing and pull
out the rivet mandrel. Use an airline to blow out the
filings, oil and re-assemble the jaw housing.
Clean out the nozzle.
No suction.
The shut-off valve has not been opened.
Open shut-off valve.
Air leaking.
Damaged O-rings.
O-rings must be replaced.
Loose screws.
Tighten screws.
Tool runs slow or suffers a loss of
power.
Air line is loose.
Re-install and tighten airline.
Exhaust port is blocked.
Clean out exhaust port.
Operating pressure is too low.
Increase the operating pressure to 85-95psi.
If the pressure exceeds 105-110psi, the safety valve
will operate.
7. TROUBLESHOOTING
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
.
Original Language Version
SA316.V2 Issue:3(L) - 12/02/15
© Jack Sealey Limited
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk