Sealey SA151 - Manual (Page 2)

2. INTRODUCTION & SPECIFICATION
3.1. Air Supply
3.1.1. Ensure that the grinder air valve (or throttle) is in the "off" position before connecting to the air supply.
3.1.2. You will require an air pressure between 70-90psi, and an air flow according to the specification above.
3.1.3.  WARNING! Ensure the air supply is clean and does not exceed 90psi while operating the grinder.
Too high an air pressure and/or unclean air will cause excessive wear, and may be dangerous, causing
damage and/or personal injury.
3.1.4. Drain the air tank daily. Water in the air line will damage the grinder and invalidate your warranty.
3.1.5. Clean air inlet filter weekly. Recommended hook-up is shown in fig.1.
3.1.6. Line pressure should be increased to compensate for unusually long air hoses (over 8 metres).
The minimum hose diameter should be 1/4” I.D. and fittings must have the same inside dimensions.
3.1.7. Keep hose away from heat, oil and sharp edges. Check hoses for wear, and make certain that all
connections are secure.
3. PREPARING GRINDER FOR USE
1.2. LEAD PAINT WARNING!
Paint once contained lead as a traditional ingredient. Contact with the dust from the removal of such
paint is toxic and must therefore be avoided. The following action must be taken before using the
grinder on a surface that you suspect may contain lead paint.
1. User must determine potential hazard relating to age of paint to be removed (modern paints do
not have lead content).
2. DANGER! Keep all people and pets away from the working area. The following are particularly
vulnerable to the effects of lead paint dust: Pregnant women, babies and children.
3. We recommend personal protect ion by using the following safety items:
a) Paint Spray Respirator (Our ref SSP1699)
b) PE Coated Hooded Coverall (Our ref SSP267). c) Latex Gloves (Our ref SSP24).
4. Take adequate measures to contain the paint dust, flakes and scrapings.
5. Continue to wear safety equipment as in (3) above and thoroughly clean all areas when work is
complete. Ensure that paint waste is disposed of in sealed bags or containers according to
local regulations.
Disc Diameter: . . . . . . . . . . . . . . . . . . 180mm
Free Speed: . . . . . . . . . . . . . . . . . . . 6000rpm
Operating Pressure: . . . . . . . . . . . . . . .90psi
Air Consumption: . . . . . . . . . . . . . . . . . 21cfm
Air Inlet: . . . . . . . . . . . . . . . . . . . . . . 3/8”BSP
Noise Power: . . . . . . . . . . . . . . . 119.21dB(A)
Noise Pressure: . . . . . . . . . . . . . 108.21dB(A)
Vibration Figure: . . . . . . . . . . . . . . . . . 3.9m/s²
Uncertainty Value: . . . . . . . . . . . . . . 0.53m/s²
Weight: . . . . . . . . . . . . . . . . . . . . . . . . . .3.1kg
Well balanced professional tool with side handle, polished aluminium bevel gear housing and throttle body.
Fitted with throttle safety device to prevent accidental operation and steel disc guard for added safety. Supplied
with spanner and hex key. Suitable for heavy workshop use. Not suitable for use with cutting discs.
SA151.V2 Issue: 2(SP)- 31/07/13
Original Language Version © Jack Sealey Limited