Epson Stylus NX300 - Manual (Page 39)

Replacing Ink Cartridges 39
4. Before you open the new cartridge package, shake it four or five times. Then
remove it from the package.
Caution:
Do not touch the green chip on the front of the cartridge. This can damage the ink
cartridge.
5. Remove the yellow tape from the bottom of the ink
cartridge.
Caution:
Do not remove any other labels or seals, or ink will leak.
6. Insert the new ink cartridge into the holder and push
it down until it clicks into place.
7. Once you replace all the cartridges that need
replacing, close the cartridge cover and push it down
until it clicks into place.
8. Close the scanner.
9. Press OK to begin charging the ink. This takes about 2 minutes. When you
see a completion message on the display screen, ink charging is finished.
Caution:
Never turn off the NX300 Series while ink is charging, or you’ll waste ink. If you see an
ink replacement message on the display screen, press OK and press down all the
cartridges securely.
If you remove a low or expended ink cartridge, you cannot reinstall and use the
cartridge.
NX300_QG.book Page 39 Wednesday, May 7, 2008 10:42 AM