Miomare Sink Mixer Tap / Kitchen Mixer Tap / Bath and Shower Mixer Tap - Manual (Page 33)

33 GB
Operation / Maintenance and Cleaning
Cold water:
Swing the handle
22 to the right.
Check operation of the mixer. To do so, swing
the handle 22 into all permissible positions.
Please regularly check the connections are
tight.
Eco Function /conserving water
The cartridge 28 in this tap has an Eco function.
The feature limits the water flow through the tap.
This means you can save water by up to 50 %
(see fig. C).
Lift the handle 22 until you notice a slight resist-
ance. This resistance will cause a stop in case
of partial opening and will therefore simply
limit the flow of water.
If you want to increase the flow rate, exert
slight pressure on the handle 22 until you
overcome the resistance.
Setting the scald protection
The cartridge 28 in this tap has a scald protection
function. This function is not activated before
leaving the factors (neutral setting) (see fig. D/I).
Note: Do not alter the setting of the scald
protection until you have installed the tap.
Please note: This step requires an Allen key
(2.5 mm)
21 and an open-ended spanner
SW 30 mm of fitting pliers.
Follow these steps:
Shut off the main water supply. Allow any
remaining water in the pipework to drain.
Remove the hot/cold plaque 24 by adjusting
the handle 22 to the highest position and in-
serting a flat object between the edge of the
hot/cold plaque
24 and the outside of the
handle 22 .
Please Note: Use light pressure to carefully
push the hot/cold plauqe
24 outwards so as
not to scratch the surface.
Loosen the locking screw 23 with the socket
head wrench 21 by turning it counter-clock-
wise.
CAUTION! Do not unscrew the screw com-
pletely. Only loosen this as far as is necessary
to remove the handle
22 .
Remove the handle 22 .
Unscrew the cartridge covering ring 25 , do not
use pliers or a spanner. Otherwise the product
could be damaged.
Loosen the cartridge locknut 26 ; this requires
an open-end spanner SW 30 mm or fitting
pliers.
Now pull the red hot-water limiting ring 27
upwards using a screwdriver.
Note: Press the cartridge pins slightly back-
wards. This will make it easier to pull up on the
hot water limiting ring
27 .
Reducing the hot water flow rate:
Reinsert the hot water limiting ring 27 , as show
in Fig D/II.
Reducing the hot water flow rate completely:
Attach the hot water stop ring 27 as shown in
Fig D/III.
Deactivating the hot water flow limitation:
Attach the hot water limiting ring 27 as shown
in Fig D/I (neutral setting).
After adjusting the scald protection, attach the
cartridge locknut 26 , the cartridge covering
ring 25 and the lever 22 analogue to the
disassembly.
Maintenance and Cleaning
Maintaining and
cleaning the tap
Please note that sanitary taps require special care
and attention. Therefore, please follow the instruc-
tions:
When cleaning, never use petrol, solvents,
aggressive cleansers or hard cleaning brushes