Preparing for use / use, Assembly, Switching the tabletop fountain on and off – Melinera Z30094C-BS User Manual
Page 9
9
GB
Preparing for use / Use
Preparing for use / Use
Assembly
Note: Have a vessel filled with approx. 800 ml water ready before
you start assembly.
Unpack the product and the accessories carefully.
Note: When you are unpacking the components make sure that
you do not unintentionally throw away any of the assembly materials.
Place the water container
12
on a flat and even supporting sur-
face near a mains socket (230–240 V~, 50 Hz).
Mount the lamp attachment assembly
1
on to the ornamental
stone
2
. To do this, position the lamp attachment
4
exactly
over the holes for the lamp attachment
3
and fix it firmly in
place by screwing in the screws
5
(see Figure A). Use a PH1
screwdriver to tighten the screws.
Fill the water container
12
with water up to the MAX marking
(inside wall) of the water container
12
.
Increase (MAX) or reduce (MIN) the flow of water issuing from
the ornamental stone
2
by means the + / - slider
14
(Fig. C).
Place the base
6
with the attached pump
8
on the water
container
12
and guide the lead from the pump
8
through the
recess
16
.
Decorate the base
6
with the pebbles
13
.
Your tabletop fountain is now ready for use.
Switching the tabletop fountain on and off
Insert the adapter
11
into a properly installed mains socket to
switch the tabletop fountain on. The lamp halogen bulb
18
illumi-
nates and water flows out of the ornamental stone
2
.