Epson Cinema 200+ User Manual
Page 59
59
The picture is upside-down or reversed.
Change the
Projection
setting in the menu system (see page 34).
Only part of the picture is displayed, or the picture is distorted.
■
Press the
Aspect
button to select a different aspect ratio (see page 19).
■
If the Aspect is set to
Zoom
, you may need to use the
Zoom Caption
option to see the
top or bottom section of the screen (so that subtitles are visible). See page 33.
■
Check the
Output Scaling
to make sure it’s adjusted correctly (see page 33).
■
Use the
Position
setting to reposition the image on the screen (see page 33).
■
If you’ve connected a computer and you see only half the image, make sure the
computer’s Dual Display setting is turned off.
The picture isn’t rectangular.
■
If the image looks like
or
, the projector has been placed off to one side of the
screen and angled toward it. Face the projector straight ahead (instead of at the center of
the screen), then use the horizontal lens shift knob to center the image (see page 22).
■
If the image looks like
or
, use the remote control to access the
Keystone
function to correct its shape (see page 23). Or press the
and
buttons on the
projector’s control panel.
Note: You won’t have to use the Keystone function, as long as you place the
projector level (not angled up or down) at a height between the top and bottom of the
screen, and use the vertical lens shift knob to position the image. This produces the
best-looking picture.
The picture contains static or noise.
■
Make sure the
Input Signal
is set correctly for your connected video equipment (see
■
If you’re viewing still images and you notice flickering or horizontal lines, turn on the
Progressive
■
Make sure your cables are securely connected at both ends.
■
If you’re using an extension cable, you may pick up interference unless you use a signal
amplifier. Or try turning on
Noise Reduction
■
If you’re displaying the same image on your computer and projector screen, try turning
off your laptop’s LCD display.