Electrolux EBGL70 - Manual (Page 20)

2. Remove the metal ring and clean the
glass cover.
3. Replace the lamp with a halogen, 230
V, 40 W, 300 °C heat resistant oven
lamp.
4. Attach the metal ring to the glass cov-
er.
5. Install the glass cover.
Replacing the side lamp:
1. Remove the left shelf support.
2. Use a Torx 20 screwdriver to remove
the cover.
3. Remove and clean the metal frame
and the seal.
4. Replace the lamp with a halogen, 230
V, 25 W, 300 °C heat resistant oven
lamp.
5. Install the metal frame and the seal.
Tighten the screws.
6. Install the left shelf support.
12. WHAT TO DO IF…
WARNING!
Refer to the Safety chapters.
Problem Possible cause Solution
The appliance does not
heat up. The appliance is deacti-
vated. Activate the appliance.
The appliance does not
heat up. The time of day is not set. Set the clock. Refer to
"Setting and changing the
time".
The appliance does not
heat up. The necessary settings
are not set. Make sure that the set-
tings are correct.
The appliance does not
heat up. The fuse is released. Make sure that the fuse is
the cause for the mal-
function. If the fuse relea-
ses again and again, refer
to an authorized electri-
cian.
The lamp does not oper-
ate. The lamp is defective. Replace the lamp.
The display shows an er-
ror code that is not in this
table. There is an electronic
fault. • Deactivate the appli-
ance with the house
fuse or the safety
switch in the fuse box
and activate it again.
• If the display shows the
error code again, refer
to the Service Center.
20 www.electrolux.com