E-57, Flash indicator – Casio QV-3EX User Manual
Page 56
RECORDING
E-57
Flash Indicator
When you press the shutter button half way, the flash icon
appears on the monitor screen and the Flash lamp light (am-
ber) to indicate that the flash will fire when the shutter button
is pressed the rest of the way down.
IMPORTANT!
• Never use the flash in areas where combustible or ex-
plosive gas is present. Doing so creates the danger of
fire and explosion.
• Never fire the flash in the direction of a person operat-
ing a motor vehicle. Doing so can interfere with the
driver’s vision and create the danger of accident.
• Never fire the flash while it is too close to the subject’s
eyes. Intense light from the flash can cause eye dam-
age if it is fired too close to the eyes, especially with
young children. When using the flash, the camera
should be at least one meter from the eyes of the sub-
ject.
• Make sure that you do not touch or block the flash or
exposure sensor with your fingers. Doing so can soil
these components and interfere with correct flash op-
eration.
Exposure sensor
Flash
• Flash should be used for distances within the range of
about 0.7 meters (2.3´) to 3 meters (9.8´) (values with
fully open aperture). Flash does not work well outside
these ranges.
• Depending on operating conditions (type of batteries
being used, temperature, etc.), it may take up to 40
seconds for the flash unit to charge.
• The flash is disabled during movie and continuous re-
cording, which is indicated by the flash icon appearing
on the monitor screen.
• The flash unit does not charge when battery power is
low. The
indicator appears to warn you that the
flash will not fire correctly, which may affect exposure
of the image. Replace batteries as soon as possible
when this happens.
• Red-eye reduction may not work well when the cam-
era is not pointed directly at the subject or when the
subject is far from the camera.
• In the Red-eye Reduction Mode, the flash is fired au-
tomatically in accordance with exposure. Because of
this, the flash does not fire in a well-lit area.
• In the Manual Mode (M Mode), the flash does not fire if
Auto Mode or Red-eye Reduction Mode is currently
selected as the flash mode.
• White balance is fixed while the flash is being used, so
the coloring of the recorded image may be affected by
sunlight, fluorescent lighting, or other sources of illu-
mination in the immediate area.