Casio EX-P600 - Manual (Page 66)

66
BASIC IMAGE RECORDING
Flash Unit Status
You can find out the current flash unit status by pressing
the shutter button half way and checking the monitor
screen and red operation lamp.
BKT
Red operation lamp*
The indicator is also
shown on the monitor
screen when the flash unit
is ready to fire.
* Red operation lamp
It means this:
Flash unit is charging
Flash unit is ready to fire
When the red operation
lamp is this:
Flashing
Lit
Changing the Flash Intensity Setting
Perform the following steps to change the flash intensity
setting.
1.
In the REC mode, press [MENU].
2. Use [
왗
] and [
왘
] to select the “REC” tab.
3.
Use [
왖
] and [
왔
] to select “Flash Intensity”,
and then press [
왘
].
4. Use [
왖
] and [
왔
] to select the setting you
want, and then press [SET].
To do this:
Fire the flash with strong intensity
Fire the flash with normal intensity
Fire the flash with weak intensity
Select this setting:
Strong
Normal
Weak
NOTE
• Flash intensity may not change if the subject is too
far or too close to the camera.