Emerson Liebert Remote Monitoring Panel - Manual (Page 9)

Installation
5
Figure 4 Communication cable connection
2.5 Mounting the RMP on Drywall
To hang the RMP on drywall or similar surface:
1. Drill four holes (6mm-by-26mm) in the wall, spacing them as shown in Figure 5.
2. Insert the four factory-supplied, plastic anchors into the holes.
3. Insert one screw into each anchor and tighten firmly.
4. Remove the four hooks from the RMP, reverse them, then reattach them to the RMP.
5. Hang the RMP on the wall by slipping the hooks over the heads of the screws and lowering the
RMP slowly until the screws are seated in the slotted portion of the hooks.
Figure 5 Mounting hole dimensions
UPS_U2_J24
Up to 328 ft. (100 m)
RMP_X1_J1
Shield
Shield
485-
485+
485-
485+
1
2
3
4
1
2
3
4
S TATUS
Remote Monitor Panel
S ILE NCE ON/ OFF
Liebert NX Emerson
Network P ower
TM
14-3/16"
(365mm)
12"
(306mm)
F1 F2 F4 F3 HELP