Enterasys Networks Enterasys Matrix 9034310-01 User Manual
Page 43

Using LANVIEW
Matrix DFE-Platinum Series Installation Guide 4-3
CPU
None
Power off.
Ensure chassis has adequate power.
Amber
Blinking. Module in process of
booting.
None.
Solid. Testing.
If the LED remains amber for several
minutes, contact Enterasys Networks for
technical support.
Green
Blinking. Image starts running.
None.
Solid. Functional.
None.
Red
Solid. Processor in reset.
None.
Green
and
Amber
Blinking. Indicates that the
module is in the process of
shutting down.
None. This state is activated when the
OFFLINE/RESET switch is pressed for less
than 1 second to a start the process of an
orderly shutdown.
While in this state, do not remove any
DFE-Platinum module.
Amber
and off
Alternating (67% on, 33% off).
Indicates that a shutdown
process has completed. This
indication will remain for 60
seconds before automatically
restarting.
While in this state, you have 60 seconds to
safely remove the DFE-Platinum module
from the chassis.
RX
(Receive)
None
No link. No activity. Port
enabled or disabled.
None.
Green
Solid. Link present, port
enabled, no traffic is being
received by the interface.
None.
Amber
Flashing. Link present, port
enabled, traffic is being received
by the interface.
None.
Red
Blinking. Indicates collisions.
This indication is only supported
on 10/100 ports.
Contact Enterasys Networks for technical
support.
TX
(Transmit)
None
Port enabled, but no activity.
If it is known that the port should be active
and is not, contact Enterasys Networks for
technical support.
Green
Flashing. Indicates data
transmission activity. Rate of
flashing indicates the data rate.
None.
Red
Flashing. Fault or Error
(collision).
None, unless there is a high rate of activity.
In this case, check for network configuration
problems or a defective device.
Table 4-1 LANVIEW LEDs (continued)
LED
Color
State
Recommended Action