beautypg.com

Setting the jumpers – Epson EL 3S/33 User Manual

Page 47

background image

Setting the Jumpers

If you need to change any jumper settings, follow these steps:

1. Refer to the illustration on page 3-5 to locate the jumpers.

2. If there are any option cards installed in your computer, you

need to remove them to access the jumpers. See page 3-16.

3. A jumper’s setting is determined by where the jumper is

placed on the pins. A two-pin jumper either connects both

pins (on) or sits on just one of the pins (off). For three-pin

jumpers, the jumper connects pin 1 and the middle pin

(position 1-2) or pin 3 and the middle pin (position 2-3), as

shown below.

1

1 - 2

2 - 3

To move a jumper from one position to the other, use

needle-nose pliers or tweezers to pull it off its pins and

gently move it to the desired position.

Caution
Be careful not to bend the jumper pins or damage any

surrounding components on the main system board.

4. Replace any option cards you removed. See page 3-13 for

instructions.

3-8

Installing and Removing Options