Epson EL 3S/33 - Manual (Page 19)

Caution
To avoid damaging the connector, be careful not to bend
the pins when you insert it.
4. If the connector has retaining screws, tighten them.
5. Plug the monitor power cord into the monitor’s power inlet.
6. Plug the other end of the power cord into an appropriate
grounded electrical outlet or into the power outlet on the
back of the CPU.
Caution
If you plug the monitor’s power cord into the back of your
computer, make sure the monitor’s power requirements do
not exceed 1 Amp.
Connecting a Printer of Other Device
Your computer has one parallel and two serial ports. To
connect a printer or other peripheral device, follow the
appropriate instructions below.
Using the Parallel Port
Follow these steps to connect a parallel printer to your
computer:
1. Place the printer next to the computer so that the backs are
facing you.
2. Align the connector end of the printer cable with the
PARALLEL
port and plug it in. If the connector has retaining
screws, tighten them.
Setting Up Your System 1-5