Elmo Network Pan-Tilt-Zoom Camera PTC-201CIP - Manual (Page 43)

- 42 -
[5] LIVE connection list - Listing the clients connected to the
LIVE page
This function is intended to display in list form the IP addresses of the clients connected to
the LIVE page of the Camera , the authenticated clients, and the duration of connection.
Also, if a client connected has an unauthorized address, it is possible to break the
connection from on the list.
Display method
• Enter the IP address or host name (if allocated) of the Camera , following [http://],
followed by [/config.htm], in the Address bar’s text box of the Web browser. For
example, enter the IP address of this Camera as “http://192.168.0.100/config.htm”,
since it has been factory set to 192.168.0.100.
• When the Authentication page is displayed, undergo authentication by the [root]
account. Authentication cannot be cleared successfully by any other account. (The
Authentication page is not displayed, since no password has been set in as-shipped
condition.)
• When the Configurations page is displayed in the Web browser, click the link [LIVE
[6] telnet server functions – Performing remote operation and
acquiring the status
This Camera can be remotely controlled and its status can be acquired through telnet.
For the information of the command, etc., consult your dealer or an authorized ELMO
service center.
Connection List] .
• When the LIVE connection list
appears, the number of clients
connected, the IP address, account,
and duration of connection, of each
client, are displayed in list form.
When the refresh button is clicked,
the contents of the list are updated.
When there is a client connected,
the [Disconnect] button is shown in
the rightmost column of the list. In
order to avoid the LIVE page from
being seen because of an
unauthorized address or for other
reason, click the [Disconnect]
button to break the connection to
that client.