Elmo Network Pan-Tilt-Zoom Camera PTC-201CIP - Manual (Page 41)

- 40 -
[4] IP address filtering functions - Restricting clients who have
access to the Camera
This function is intended to restrict clients who have access to the Camera . By registering
the IP address allocated to each client, access to the Camera can be permitted. The number
of clients that can be registered is limited to 10. One of those clients is granted
administrative privileges.
Reference Page [7] Configurations
IP address filtering Configurations P.43
The Camera provides the following two procedures of setting the IP address filtering
function.
• Connecting to the Camera from the host on the network through the Web browser.
• Connecting to the Camera from the host on the network through telnet.
Here, the setup procedure using the Web browser is described.
For the setup procedure using telnet, consult your dealer or an authorized ELMO service
center.
Setting
• Enter the IP address or host name (if allocated) of the Camera , following [http://],
followed by [/config.htm], in the Address bar’s text box of the Web browser. For
example, enter the IP address of this Camera as “http://192.168.0.100/config.htm”,
since it has been factory set to 192.168.0.100.
• When the Authentication page is displayed, undergo authentication by the [root]
account. Authentication cannot be cleared successfully by any other account. (The
Authentication page is not displayed, since no password has been set in as-shipped
condition.)
• When the Configurations page is
displayed in the Web browser, click
the link [IP Address Filtering
Configuration] .
• When the IP Address Filtering
Configuration page is displayed, enter
the IP addresses for which access to
the Camera is permitted. To reset the
changed settings to the original
settings, click the clear button
[CLEAR] .
• When all items have been set, click the
submit button [SUBMIT] . When the IP
address for the administrator is
changed, the message “You are now