Elmo Network Pan-Tilt-Zoom Camera PTC-201CIP - Manual (Page 30)

- 29 -
Connection to the network
• Connection using HUB
Connect the Ethernet terminal (RJ-45) of the Camera to the HUB port with an
Ethernet straight cable (UTP Category 5). For the HUB port, use a port other than the
MDI port.
• Connection to one host
Connect the Ethernet terminal (RJ-45) of the Camera to the Ethernet terminal of the
host with an Ethernet cross cable (UTP Category 5).
Setting up of the network
• Start the Web browser from the host
connected to the Camera.
• Enter the IP address or host name (if
allocated) of the Camera , following
[http://], followed by [/config.htm], in
the Address bar’s text box of the Web
browser. For example, enter the IP
address of this Camera as
“http://192.168.0.100/config.htm” since
it has been factory set to 192.168.0.100.
• When configuration page is displayed
in the Web browser, click the link
[Network Configuration] .
Note: Upon connection of this Camera to other unit on the network through the
Ethernet terminal, the communication protocol is adjusted automatically
between the Camera and the connected unit to 10BASE-T/100BASE-TX and
HDX/FDX (i.e., “automatic negotiation”). Therefore, this Camera may not be
properly connected to some units on the network that do not comply with
automatic negotiation.