LW Scientific Digital ZipSpin - Manual (Page 4)

Interchangeable Rotor
8-Place Rotor
8 x 0.2 ,0.4 ,0.5 ,1.5 ,2 ml
PCR Rotor
16 x 0.2 ml
Changing the Rotor
Insert the L-arm hex wrench into the marked hole on the side of the rotor. The grub screw is located at the bottom of the
rotor on the marked side.
To remove the rotor, turn counter-clockwise to loosen the screw. Gently pull the rotor up.
Insert the new rotor from the top onto motor shaft and tighten the screw again. Turn clockwise to tighten screw, which
is located under the bottom of rotor.
Please make certain the rotor is tight enough to avoid any accident.
3
4
1
2
Rotor
Set Screw
Wrench
Motor Shaft