LW Scientific Digital ZipSpin - Manual (Page 2)

Operation
Switch ‘On’ the centrifuge from rear side so that display will show you the readings.
Note : ‘En’ Symbol indicates that Imbalance detection feature is enabled.
Load the rotor symmetrically to avoid accident and damage of centrifuge.
Close the lid to start centrifugation. Use the Speed knob to set the speed and the Timer knob to set the run time.
Once the centrifugation is completed, turn speed knob or use timer knob to set the display value to zero. This will
gradually stop the rotor.
If you want to stop the centrifuge quickly, push the lid release button and the rotor will stop within 2 seconds.
After the rotor has stopped, press the lid release button and open lid with your thumb in front and fingers on the top -
simply lift the lid back on the hinge.
2
3
1
4
5
Installation
The Digital ZipSpin Centrifuge is supplied in a Box. Open the Box, then carefully remove centrifuge from the Box and
connect the electrical cable. The instruction manual and the accessories should be kept with the centrifuge. Please
keep all packaging in safe storage for at least 1 year for warranty purposes.
Make sure the rotor is tight enough to avoid any accident. Load the rotor with Micro tubes for centrifugation. Flip on the
switch on the rear, set the desired speed and time and close the lid to start centrifugation.
On/Off Switch Power Socket