Lanner FW-8894 - Manual (Page 16)

Chapter 3:
Hardware Setup
Preparing the Hardware Installation
WARNING: To reduce the risk of personal injury,
electric shock, or damage to the equipment,
remove the power cord to complete shut down
the device. The rear panel Power On button does
not completely shut off system power. Portions
of the power supply and some internal circuitry
remain active until AC power is removed.
Power off FW-8894 and make sure the power cord is 1.
disconnected from the device.
Remove the 3 circled screws at the rear of the top
2.
compartment and 2 from each side.
Gently pull the cover backward . 3.
Open the cover from the side. 4.
Installing CPU and the Heat Sink
Follow the procedures below for installing a CPU
1. Locate the CPU socket(s)
2. Press the left load lever down, move it out of the
retention tab. Then, do the same to the right. There are
two levers for each CPU socket.
3. Lift the load levers.
Press down
Press down