Lanner FW-8760 - Manual (Page 12)

7
Introduction
Chapter 2
Network Application Platforms
Align the riser card with the PCI-E golden finger 1.
connector.
Insert the card into the connector firmly.
2.
Fasten the screws to fix the card onto the board. 3.
Riser Card Installation
3 2
Front Ethernet Module Installation
To install the front Ethernet module, take off the front 1.
bracket first by unscrewing the threaded screws at the
bottom of the case.
Insert the Ethernet module into the front expansion
2.
slot. You should a click when the module connects to
the Riser Card.
Fasten the screw back at the bottom of the case to
3.
secure the module on the system.